| View previous topic :: View next topic |
| Author |
Message |
DIGGINSWEATINSWEARIN
Joined: 02 Nov 2010
Posts: 47
Location: Deroche B.C.
|
 Posted: Tue Oct 30, 2012 8:03 am Post subject: Sealing a plastic bow tank?? |
 |
|
Hi,
My vent fitting in my bow tank was put a little too close to the drawer housing and I guess the vibration has caused the fitting to leak. The previous owner had put some kind of goo around it to seal it but it has not worked. I was wondering if there was a better way to fix this ?
thanks, Darren
| Description: |
|
| Filesize: |
38.16 KB |
| Viewed: |
12298 Time(s) |
|
|
|
| Back to top |
|
 |
trancendenz
Joined: 25 Oct 2012
Posts: 2
Location: Yellowknife
|
| Posted: Tue Oct 30, 2012 10:52 am Post subject: Sealing a plastic bow tank?? |
|
|
Not sure about the boating world, but on airplanes we used to use JB WELD to do minor repairs to fuel tanks and stuff. Seemed to work because the fuel wouldn't eat through it... Piston Airplanes so it was Leaded Gasoline too.
Maybe worth a shot?
_________________
Drive it til the last piece stops moving!!! |
|
| Back to top |
|
|
REPO
Joined: 09 Sep 2011
Posts: 179
|
| Posted: Tue Oct 30, 2012 7:34 pm Post subject: |
|
|
| If it were me, I'd remove it a epoxy a plastic patch over the hole, the relocate it to a new spot.
|
|
| Back to top |
|
|
Rapidchaser
Joined: 26 Feb 2006
Posts: 198
Location: Edmonton
|
| Posted: Fri Nov 02, 2012 10:49 am Post subject: Leak |
|
|
clean it well and if it is steel , solder it with an iron--no flame.
If it is aluminium, JB weld like someone said 
_________________
FORD=Power for the thrills of life!
Keep the wet side down! |
|
| Back to top |
|
|
Rapidchaser
Joined: 26 Feb 2006
Posts: 198
Location: Edmonton
|
| Posted: Fri Nov 02, 2012 10:53 am Post subject: strike that lol |
|
|
Just re-read the header oops what A/H I am
_________________
FORD=Power for the thrills of life!
Keep the wet side down! |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
