| View previous topic :: View next topic |
| Author |
Message |
show u one time
Joined: 06 Mar 2010
Posts: 63
Location: whitehorse yukon
|
 Posted: Mon May 02, 2011 7:50 pm Post subject: throttle control |
 |
|
| any one know how to take the throttle control assembley off?? im tryin to get the panel off to get reupholstered and cant seem to figure out how to get the throttle assembly off, out, do ya gotta un hook the cables at the pump and carb. and pull the cables out that way?? or ??????, 1998 eagle e6, morse throttle shifter control. any help would be greatly appreceated!!! the river is open and we need to get the upholstery done and back in the boat! thanxs all!!! |
|
| Back to top |
|
 |
gasfitter67
Joined: 13 Jun 2010
Posts: 24
|
| Posted: Mon May 02, 2011 9:30 pm Post subject: Re: throttle control |
|
|
| show u one time wrote: | | any one know how to take the throttle control assembley off?? im tryin to get the panel off to get reupholstered and cant seem to figure out how to get the throttle assembly off, out, do ya gotta un hook the cables at the pump and carb. and pull the cables out that way?? or ??????, 1998 eagle e6, morse throttle shifter control. any help would be greatly appreceated!!! the river is open and we need to get the upholstery done and back in the boat! thanxs all!!! |
|
|
| Back to top |
|
|
Boomhower
Joined: 03 Nov 2007
Posts: 995
|
| Posted: Tue May 03, 2011 10:20 am Post subject: |
|
|
| If you remove the screws holding the bezel into the panel. Then check under the dash and make sure there is enough slack in the cables. You may have to cut a few zip ties. then pull the control out and to the rear. It will be tight. The vinyl side panels are snug fitting. Once the control is pulled through you can disconnect the cables by undoing the cotter pins and the cable clamps. |
|
| Back to top |
|
|
show u one time
Joined: 06 Mar 2010
Posts: 63
Location: whitehorse yukon
|
| Posted: Wed May 04, 2011 8:49 am Post subject: |
|
|
| Boomhower wrote: | | If you remove the screws holding the bezel into the panel. Then check under the dash and make sure there is enough slack in the cables. You may have to cut a few zip ties. then pull the control out and to the rear. It will be tight. The vinyl side panels are snug fitting. Once the control is pulled through you can disconnect the cables by undoing the cotter pins and the cable clamps. |
thanxs dude,, got the control out the cable was tight ,,unhooked the cable from the bucket and pushed it in,, that gave enough slack to get it out! |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
