OUTLAW EAGLE MANUFACTURING

Arthur

Just wondering if any 'play' in the front yoke is accectable? I had this bearing replaced when I first got the boat and when greasing it this morning I checked it for movement, and it seemed a lil' exsessive. I'm assuming it should be fairly snug?

TOP DAWG · Posted: Sat May 02, 2009 10:37 am Post subject:

about zero movement is good. Is it up and down or front anb back. Either way is no good, it's possible the bearing was improperly installed

Arthur · Posted: Sat May 02, 2009 10:45 am Post subject:

Up and down and side to side (same shit). I'm guessing if there's enough play there to be a concern I should get it replaced and not try and make the year? This means pulling the motor to replace that correct?

Hines · Joined: 05 Jul 2005 Posts: 304 Location: Red Deer

You will not make the year unless your leaving it in the shop / i dont think you have to pull the power plant it will give you more room /you will not like what happens when that bearing goes away crank????.Later.

jack · Joined: 16 Jun 2008 Posts: 31

Just look at their website , they have manuals
Check it out

Arthur · Posted: Mon May 11, 2009 9:24 am Post subject:

Yeah thanks guy's. I got the manual and the part's....just need some time and a hand to get it done. Should be running by the W/E.