OUTLAW EAGLE MANUFACTURING

[riverboater]

Looking to strip out the boat, 468 BBC engine complete from motor mounts to sand trap, 852 Scott complete from stomp grate to tilt nozzle, all controls, steering etc. Power and pump has about 2 hours on refresh. Engine total hours about 25, had a ring issue. Come help strip and you will get all hardware required including the intake block. Several spare pump parts, nozzles, impellors. I will even toss in the fuel tanks.
22g Canadian.
Everything required except the aluminum hull.

[riverboater]

Including the intake block for pump mounting

[riverboater]

BUMP
Have trouble thinking nobody is building a new boat. Yes 22g is a bunch of cash, but we are talking everything required except the aluminum hull. Price out a new motor and pump, you might find I am not that far out of line.
OR, I will trade straight across for a 115hp 4 stroke 25 inch leg C/W controls, prop and hydraulic steering.

[riverboater]

ENGINE
Gen V 4 bolt block, aftermarket rods, 9.8 to 1 compression, hydraulic roller cam, crane roller rockers, Edelbrock heads, performer intake, 750 quick fuel carb. Kodiak manifolds, mercruiser heat exchanger, aluminum 4 point mounts,
Fresh water cooled, oil cooler, all the good stuff. Timing set for 92 octane, will run 89 if Timing set to 32 total.
Dynoed at 650 lbs torque and HP / Torque cross at 550 at 5200. This engine built for low RPM power.

WILL sell engine separately

[riverboater]

Power sold, pump still available.