OUTLAW EAGLE MANUFACTURING

MOriverbum · Joined: 26 Jul 2010 Posts: 51

So I sold my high window delta, and bought a 20ft step tech . My question is, at 3k+ rpm I can hardly turn the wheel, but at idle and slow speeds it turns free. Would this be a cable issue?

Arthur · Posted: Fri Sep 16, 2011 7:43 pm Post subject:

When I went thru my issues mine was shitty ALL the time, possibly pins and bushings on the pump or it's binding under load? Boomhower should be along shortly.....he knows a bit Smile

ALEX · Joined: 02 Aug 2005 Posts: 176 Location: red deer

What type of nozzle is on your new boat ....the fabricated deflector type nozzles can be hard to turn at speed as you are deflecting the water stream ....

MOriverbum · Joined: 26 Jul 2010 Posts: 51

Place diverter behind a 309, My last boat was set up the similar but turned freely.

hardhitter · Joined: 24 Jun 2010 Posts: 11

I had this exact problem with my lynx, earlier this year. It was the steering cable and cost about 500 dollars to replace at outlaw.

TOP DAWG · Posted: Sun Sep 18, 2011 9:38 am Post subject:

ive been running hydraulic steering in my boats and ill never go back to cables. Steers the same year after year and is much easier to tuRn the wheel. Teleflex makes one that replace the conventional helm, its bolt in and not that expensive. Call Outlaw they will sell you the setup