| View previous topic :: View next topic |
| Author |
Message |
$umfun
Joined: 13 May 2007
Posts: 16
Location: overhere
|
 Posted: Thu Aug 26, 2010 1:18 pm Post subject: plastic wear ring |
 |
|
| I am thinking about installing a plastic wear ring in my american SD 309. Wondering if any body else has done this. Pros. cons. installation. |
|
| Back to top |
|
 |
towman
Joined: 05 Aug 2009
Posts: 54
Location: Grande Prairie
|
| Posted: Thu Aug 26, 2010 2:39 pm Post subject: |
|
|
| I've had 2 stainless that stood up unbelievably well, never tried plastic and not sure of cost comparison but the stainless was definately money well spent. |
|
| Back to top |
|
|
sandman
Joined: 15 Jun 2005
Posts: 260
Location: The captains table
|
| Posted: Fri Aug 27, 2010 9:22 am Post subject: |
|
|
I had one and initially liked it in my berkely JC, but eventually hated it when it came out and turned into a big hone stone on my suction piece! Totally screwed the suction piece! The right size of pebble got into the gap and when it all started spinning, the end was quick. Stick with a good stainless shouldered wear ring and you won't have the potential for an expensive day.
_________________
It was like that when I got there! |
|
| Back to top |
|
|
$umfun
Joined: 13 May 2007
Posts: 16
Location: overhere
|
| Posted: Sat Aug 28, 2010 10:24 am Post subject: plastic wear ring |
|
|
| Thanks for the replies guys. I think I will stay with the stainless. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
