OUTLAW EAGLE MANUFACTURING

[NO BRAKES]

I have a 90's outlaw 19ft v bottom. I picked up a set of wings from burnt lake and before I cut into the side of my hull im wondering if the angle of the side of my hull is the same as a newer step-tech or tunnel? by eye the through-hole brackets dont seem like they will put the bar level and still mount up flush to the hull. measure three times cut once right. thanks for the help guys. the writing in the picture is small but the area in the box is the angle in question.

[Kev-o]

Chances are slim that the angle is the same. For sure they will have to be altered a bit or new throughhull pcs made.

Cool ol' boat Good luck
Kev-o

[TOP DAWG]

the wings will fit, the little brackets maybe not ? for measuring, id sugest you use a level and put your boat perfectly level and then use some 2 sided tape and stick move the little brackets around and see if you can get them level as well.

[NO BRAKES]

as I suspected. thanks boys. basically need to fit the through pipe and then have the mounting plate welded onto that. one step at a time.