OUTLAW EAGLE MANUFACTURING

show u one time · Joined: 06 Mar 2010 Posts: 63 Location: whitehorse yukon

got a question for you all, brought the boat home last week and did the service on it, took her out to the lake and went for a spin, starts great, idles fine, runs good,,,,but,, when i put the hammer down all i can get out of it is 3500 rpm? 351 w 650 4 barrel, s.d.309 in a 21 eagle e6,aa impellor, last summer we were pullin 4300 rpm all summer no problem, didnt do any thing different to the engine when i serviced it, new oil, new plugs. the 4 barrls dont seem to be opening up, but buddy was watchin when we were testing and says they are open????how is this possible?? and advice would be great,, thanxs!

Bald Man · Posted: Mon May 24, 2010 11:07 am Post subject:

Check your plug wires and timing. I had a crossed plug wire once and my boat would idle, start and run fine other than it was low on RPM (sounds the the same as yours).

show u one time · Joined: 06 Mar 2010 Posts: 63 Location: whitehorse yukon

thanxs bald man,, i was thinkin that also, as i did hafta change one plug wire, and i was thinkin i migt have put two on backwards.ill give that a try and see what happens, thanxs for the advice!!!!

BLOWN INCOME · Posted: Mon May 24, 2010 12:48 pm Post subject:

also check to see if there is fuel in the secondary float bowl..just a thought

show u one time · Joined: 06 Mar 2010 Posts: 63 Location: whitehorse yukon

good call!! the 4 bubble, didnt seem to be dumpin any fuel, there was no big jump or boost, the float be stuck? or a pluged jet? guess ill be doin a little tinkerin tomorrow! thanxs for the info guys!!

Hines · Joined: 05 Jul 2005 Posts: 304 Location: Red Deer

You might what change feul filters,put the hammer down shut down pull and read plugs.Later.