OUTLAW EAGLE MANUFACTURING Forum Index OUTLAW EAGLE MANUFACTURING
ALUMINUM BOAT FORUM
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Newbe has boat questions
Goto page Previous  1, 2
 
Post new topic   Reply to topic    OUTLAW EAGLE MANUFACTURING Forum Index -> OE GENERAL FORUM
View previous topic :: View next topic  
Author Message
ravencrew



Joined: 24 Oct 2006
Posts: 216
Location: Brookings Or.

PostPosted: Tue Mar 30, 2010 6:09 am    Post subject: Reply with quote

I owned a 20' E6 saber with a delta bottom and the marine 350. Basically it was a ZZ4, 6 degrees of bottom,it had a jetovator attached to an AT pump with a "AA" impeller. We were limited to how many people and gear we could run up river. I think during a funeral I had 7 adults and 3 kids. Drug my rear just once through the bottom getting on plane. We had so much fun running that boat. The wife didn't like how it turned she said. Could be we weren't running full speed and the trim was not fully adjusted too. Any how I thught it turned just fine for it's size. I clocked the boat with 4 adults and two kids going upriver at 54 and downriver at 61. We took the boat to the lake to try it out, I'm use to running rivers so lake boating was a whole new experience. We ended up in the air more then in the water due to green rollers in the lake. We had a blast though. We sold the boat not because we didn't like it, We sold it due to the ecomony and pay cuts. just my experience.
Back to top
View user's profile Send private message
HoldMyBeerAndWatchThis



Joined: 17 Mar 2010
Posts: 17

PostPosted: Tue Mar 30, 2010 9:02 am    Post subject: Reply with quote

Just off hand does anyboidy know the price of a LSA or ct 525, in cdn preferably, even though there shouldnt be much differance at this point being that our Dollar almost par.
Back to top
View user's profile Send private message
finally conviced her



Joined: 14 Aug 2006
Posts: 162
Location: Lacombe, AB

PostPosted: Tue Mar 30, 2010 9:20 am    Post subject: Reply with quote

Having personaly had zero river experience before my first boat. I would recomend spending an amount of money on a boat that you can afford to lose. I came very close several times to total loss. And maybe worrying about wrecking your boat and how much it could cost is a good thing. But it would sure take some of the fun out of the learning curve.
Back to top
View user's profile Send private message
Will R



Joined: 31 Jul 2005
Posts: 677
Location: NWT/Alberta

PostPosted: Tue Mar 30, 2010 9:58 am    Post subject: Reply with quote

now thats a damn good point!


When in doubt,hammer down!
Back to top
View user's profile Send private message
boosted



Joined: 04 Jun 2009
Posts: 378

PostPosted: Tue Mar 30, 2010 10:23 am    Post subject: Reply with quote

You can probably pick up a ct 525 for around 8500 cdn without marine gear. The lsa is alot more I am guessing close to 20,000 with marines gear as that is the way it comes. Somone else chime in if I am off base here.
_________________
Mark

Lets go back I think we missed one rock!
Back to top
View user's profile Send private message
rokchucker



Joined: 15 Sep 2009
Posts: 36
Location: Ft Assiniboine AB

PostPosted: Fri Apr 02, 2010 5:32 am    Post subject: Reply with quote

this might make all the racers yell and throw stuff,but dont rule out the sport jets either.
my first boat was a 1975 harbercraft w/ 200 optimax.very quick on step,nimble boat real economical to run as well.
bottoms are built fairly light though and need beefing up.top speed on still water is 44 mph according to gps.aside from a few compromises ,i couldnt be happier with
a first boat.just my 2 bits....

_________________
if ya cant hit bottom ,beat the hell outta the sides
Back to top
View user's profile Send private message
reeder



Joined: 14 Dec 2006
Posts: 177
Location: Grande Prairie, AB, Canada

PostPosted: Fri Apr 02, 2010 5:23 pm    Post subject: Reply with quote

Good point rokchuker, but not a Habercraft

Last edited by reeder on Sat Apr 03, 2010 3:24 pm; edited 1 time in total
Back to top
View user's profile Send private message
Rapid Transit



Joined: 20 Jun 2005
Posts: 206

PostPosted: Sat Apr 03, 2010 2:45 pm    Post subject: Reply with quote

was your first car a ferrarie or did you just start with a corvette ? 70 per on the water is just a tad different than on the highway
Back to top
View user's profile Send private message Send e-mail
rokchucker



Joined: 15 Sep 2009
Posts: 36
Location: Ft Assiniboine AB

PostPosted: Sat Apr 03, 2010 9:09 pm    Post subject: Reply with quote

hey reeder...im NOT a harbercraft salesman .in fact i wouldnt buy another.but i aint gonna apologize for runnin one cuz
this one treated me good.like i said good first boat.cheers. :wink:and to rapid transit:good call.also 70 moh on the river is WAAAAYYYY
diffrent than a lake.

_________________
if ya cant hit bottom ,beat the hell outta the sides
Back to top
View user's profile Send private message
don wright



Joined: 15 Oct 2009
Posts: 111
Location: GP

PostPosted: Thu Apr 15, 2010 5:26 pm    Post subject: Reply with quote

u likr 4x4ing or quadding? add a little water and some teflon and theres some good family fun. all our toys have been collecting dust since we bought our harbor extreme. its the greatest family thing we've done together. buy a boat that can take a bit of punishment. anyone one i know that thought "thats not the type of riverboating there into" has sold there rides for tougher ones. if theres no rocks you might as well but a bayliner
_________________
THE WORSE THE DRIVE.....THE BETTER THE RIDE
Back to top
View user's profile Send private message
don wright



Joined: 15 Oct 2009
Posts: 111
Location: GP

PostPosted: Thu Apr 15, 2010 5:32 pm    Post subject: Reply with quote

nice car. does it float?
_________________
THE WORSE THE DRIVE.....THE BETTER THE RIDE
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OUTLAW EAGLE MANUFACTURING Forum Index -> OE GENERAL FORUM All times are GMT - 6 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group :: Spelling by SpellingCow.