OUTLAW EAGLE MANUFACTURING

ntjetboater · Posted: Fri Jul 20, 2007 2:15 pm Post subject: Windage tray

On the zz4 are you guys using them and what type, umhw, al or steel(ss)

Thanks in advance...there will be more rookie questions coming Rolling Eyes

Alumaman · Joined: 26 Jul 2005 Posts: 306 Location: Whitecourt

The stock ZZ pan has a good "street" use windage tray. But for hard cornering such as we see on the Wct. circuits, I would recomend something with more capacity.

Dan Olson builds a pan specifically for the ZZ4. 10qt. and works good. Aslo has doors in it which the stock pan doesnt.

Just another thousand $

ntjetboater · Posted: Tue Sep 29, 2009 9:53 am Post subject:

Holy shit two years later.
I actually asked this because a buddy has his shatter into pieces somehow and destroyed his motor..it was steel.

gatr · Joined: 10 Aug 2005 Posts: 21 Location: gravel bar

With him being that late you would expect a video of the process

Alumaman · Joined: 26 Jul 2005 Posts: 306 Location: Whitecourt

Two years ago I was still prepping for a second worlds FX title..and had to keep a few secrets. Wink

DOC · Joined: 17 Jun 2005 Posts: 329 Location: Whitecourt

Not much of a secret Richard, all he had to do was phone Louie and ask him. Where were you at the last water buffalo meeting ?

DOC · Joined: 17 Jun 2005 Posts: 329 Location: Whitecourt

Also steel oil pans dont shatter into pieces by themselves, they have to have help from stuff hitting them from inside. Same goes for aluminum, trust me on this one, ive blown a lot of rods through pans.