OUTLAW EAGLE MANUFACTURING

show u one time · Joined: 06 Mar 2010 Posts: 63 Location: whitehorse yukon

any one out here know the specs. for the sequence and torque lbs. for the gt 40 valve train???,, new head gaskets installed and need specs.s for the valve train, ,, got all the other specs. for head, intake and exhaust, put new fel pro gaskets in, and need to know the proper specs. thanxs!

Will R · Joined: 31 Jul 2005 Posts: 677 Location: NWT/Alberta

lots of different need to know here bud. I'm assuming it's a hydrolic cam?and that they aren't shaft mount rockers?not shouldered studs?not pedastle mount?if so when setting the valves you follow the firing order 13726548 setting each at tdc on the compression stroke.tighten it down just until you feel the free play go out of the push rod then half a turn on the rocker nut.do this on both the intake and exhaust. once done then turn the crank 1/4 turn and do the next one. just take your time is all. good luck. if they are pedastle mount( bolt on) then same as above follow your firing order and torque them each 17-23ftlbs