| View previous topic :: View next topic |
| Author |
Message |
ntjetboater
Joined: 15 Jun 2005
Posts: 401
Location: Land of many rivers
|
 Posted: Fri Sep 11, 2009 9:07 am Post subject: Sport Jet Intake Grate |
 |
|
Hey guys,
After a few jumps and a couple dozen hours WO I noticed last nite while doing some PM that my intake is missing the two bolts that hold the front of the intake to the hull.
My mercury dealer is dumbfounded and can not help me at all with getting replacement bolts, they want me to tell them the part number of the bolt.
So what type of bolt was in there? Tapered head 1/4" X 2" ?
Post up as I want to be back on the water by lunch ! 
_________________
If you ain't hittin bottom you ain't jetboatin! |
|
| Back to top |
|
 |
ntjetboater
Joined: 15 Jun 2005
Posts: 401
Location: Land of many rivers
|
| Posted: Fri Sep 11, 2009 4:32 pm Post subject: |
|
|
come on you dogs...some one must know...
M8 X 25mm.....is it hex head, pan or tapered ?
Thread pitch....1.5?
_________________
If you ain't hittin bottom you ain't jetboatin! |
|
| Back to top |
|
|
Boomhower
Joined: 03 Nov 2007
Posts: 995
|
| Posted: Sat Sep 12, 2009 9:19 pm Post subject: |
|
|
What is your boat? 17 steptech, 240 merc with inboard mounted modified pump? If so, the bolts that hold your pump to your intake mounting plate are a 5/16nc socket head bolt 1.5 inches long,
the two in the front middle should have nuts on the bottom. |
|
| Back to top |
|
|
Itsworthit
Joined: 15 Jun 2005
Posts: 432
Location: Whitecourt
|
| Posted: Mon Sep 28, 2009 11:31 am Post subject: |
|
|
| If they go into an eagle intake, they will likely be 5/16 nc flat head countersunk hex head |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
