View previous topic :: View next topic |
Author |
Message |
Rapid Transit
Joined: 20 Jun 2005 Posts: 206
|
Posted: Thu May 12, 2011 4:22 pm Post subject: |
|
|
I've seen worse...a lot worse , but there should be a story to go along with this one ( bragging rites ) or did you do that loading it on the trailer ?
fess up !! |
|
Back to top |
|
|
DIGGINSWEATINSWEARIN
Joined: 02 Nov 2010 Posts: 47 Location: Deroche B.C.
|
Posted: Thu May 12, 2011 6:39 pm Post subject: |
|
|
Nothing to brag about, just not paying enough attention, could see the rock a mile away, in fact I just drove past it on the way up. For those that find them selves on the Lillooet river, watch for a rock about the size of a volkswagon just south of Skookumchuck. It's a sneaky one |
|
Back to top |
|
|
RED ROOSTER
Joined: 04 Aug 2010 Posts: 86
|
Posted: Sat May 14, 2011 1:26 am Post subject: dents |
|
|
I have a six foot length of I beam with half inch holes every two inches. I have a matching piece of half by two steel flat bar with the same holes. I drill holes every two inches along the dent and use half inch bolts through the hull and use the bolts to squish the dent until it's flat....
I'm in Squamish if you need any aluminum welding.
Jay
www.squamishriverjet.ca |
|
Back to top |
|
|
|