OUTLAW EAGLE MANUFACTURING

Great job showcasing Outlaw Eagle and jet boating in general! It helped fill the void a little until we can get out there on the water again.

You can now watch the episode online on Power Boat Tel ...

The engine has a 160 degree thermostat and that is where it runs, considering installing a 180, so that the heater would put out more heat while running. Going fishing tomorrow and will drain the oil ...

I see a registration number in the pics. could you possibly do a search of the registration to obtain that info?

Have a 2010 lynx with kodiak injected sbc and hamilton pump. The engine uses a liter of oil every 15 hours. We run it at 2900 to 3100 rpm depending on the load, using Shell 10-30 W oil. Is this amount ...

Went out yesterday and the problem seem to be solved, thanks to all of you for the interest and suggestions. The engine warmed up normally with out the heating spike. Even the fishing was better than ...

manifolds are clear.went back to the t stat....replacement t stat had no hole....oem t stat had one 1/8 hole.... now has three, probably going fishing towards evening. i will post the outcome. thanks ...

thanks for the tip,never thought of drilling a hole. now i think we may be getting somewhere as i suspected air lock from the start

actually it was on Thursday.

Omar at Alliance trailer in Sylvan Lake for sure. They replaced the spring suspension on my 2010 river run with torsion axles on wed. in at 9, out at 3. Now we have the clearance we need to launch in ...

thanks for the replies to my problem, checked the heat exchanger and the fuel cooler this morning, neither of them plugged. will check manifolds tomorrow and take a temp. sensor along next time out. w ...

have a 19 foot lynx with 5.7 efi and hammy pump. after launch and during warm up engine temp rises rapidly. have not let it get past 200, before shutting down. on restart temp drops rapidly to 160,and ...

Have also been out on the S.S. a couple of times at Sandy Point in the past week and the level is quite low. No problem when calm and glassy, but when it is windy with surface chop the boulders are ha ...

Here are some pics.

Thanks to all the people at Outlaw, Sharlyn, Rob, Dale, and the people in the shop. We had the new boat in the water on the S. Sask. Friday April 2nd. [ Good Friday] actually great Friday. The boat ...

I have friends that have done Med. Hat to Dief. lake several times, and yes fuel is the issue and does take some advance planning. Have just taken delivery of our first jet boat and hope to do that t ...