OUTLAW EAGLE MANUFACTURING

Sounds like we'll be staying on the Halfway , thanks for the input

Thanks Tuchodi thats where we'll launch , we're wondering about how far we are going to be able to get before it gets too crazy (need to figure out how much gas to take), we boat lots of mountain rive ...

We are going up the Halfway river for the weekend but unsure where to launch (never boated it before) , is there a launch between Ft St John & Hudson Hope where the Halfway dumps into the Peace Ri ...

Duane @ beaverlodge 780-354-3791 built it up and machined it nice and tight , try it you will not be disappointed , any sign of the sunk boat? I have been watching for it but no sign yet .

I just rebuilt my stainless steel impeller and s/s wearring in my sportjet at .008" , and it seems fine .

I boat there regularily , will watch for it . is there a contact phone #

Went up to the lower Kakwa falls for an over nighter on the weekend , great trip , good water level right now . Saw a Grizzly and a big bull Caribou (full velvet) swam across the river right in front ...

The 250 runs the same pump but about 10% faster so at the same speed the 250 will run about 300 rpm slower , 250 is about 90 pounds heavier than 200 , 250 feels more like a v-8 (more thrust). 250 is n ...

I know that sportjet pumps are 7.25" , but what are the actual diameter of a new impeller & a new wear ring ? Since they come from the factory with approx. 30/1,000 clearance one or the other is u ...

Impeller just arrived at Imoros monday (7 days UPS)they say 5-7 days backed up ,so should have it installed in about 15-18 days (june 10ish). I will gps baseline and post my findings with repitched im ...

I here claude at E X Welding in Prince George is having some different 3 &4 blade S.J. impellers cast and should be out soon , good to see some innovative ideas for sportjets.

Stator has some wear but not too bad , I will look at it while changeing impellers and build up if it's getting too wore down . I went with IMPROS as I have not heard of anyone repitching a sportjet ...

Yes not all experiments have a happy outcome , I will post my comparison / results when it goes on .

I am about to send impeller to "IMPROS" to be repitched , it is a 4 blade hi-skew , my motor is 175 sportjet . My objective is to pitch up to reduce rpm . Just wondering if anyone has done this , or h ...

My objective is to reduce rpm at any given speed . less RPM = quieter , easier on motor , possibly better fuel consumption ? ....I suspect top speed would actually be slightly reduced with this swap a ...