OUTLAW EAGLE MANUFACTURING

17 foot Alicraft insured for 45k through cooperators 500 bucks with 1 claim a few years back.

I'd have a good look at your impeller and make sure there isn't a piece of wood stuck on one of the blades. I've had it happen a. Few times now. Doesn't take much to make it inoperable.

I just got back from the lakes on Thursday. What a trip. Wish I could head back up with ya.

Thanks for the info fellas.

Thanks. I'll check them out

I have a couple of sport jet impellers that need a rebuild. Can anyone point me in the right direction? Looking for a shop in the Edmonton area if available.
Thanks

My 17' Alicraft has full UHMW and it corners like its on rails.

My 17' Alicraft has full UHMW and it corners like its on rails.

I currently have an 18 foot ali craft and I'm thinking of going with a 16 foot delta pad centre console variable 12-8 degree. I can easily haul 2k lbs now and I'm wondering what I can expect to haul ...

I also run Esso semi synthetic. I have run it since new and have 200 hours without incident.....well lot's of incidents, just not motor related incidents. Smile

I just spent a week on Williston. The Ospika and the Omineca are a good run. Be prepared to lay low if the wind picks up.It could turn into an overnighter

It's about 70ish miles and I've been quite a ways up the Finlay and it's good going. Never made it as far as Fort Ware though.

Thanks for the info fellas.The drive from Mackenzie is about 70-80 km and can take up to 2 hours towing a boat depending on the road conditions

I'm heading up to Williston lake and want to run the Ospika. Looking for any words of wisdom from people who have been there done that.Thanks

The Parsnip river is a good time with a couple of good creeks & rivers to run once you get up a bit. You can run the Pack river up into Tudya lake and then into McCloed lake. The nation is a short ...